|
|
There are 12 parts to this article:
1 -
2 -
3 -
4 <
5 -
6 -
7 -
8 -
9 -
10 -
11 -
12
Here is a look at the back of the case. The three on the left are 309k 5v linear regulators. The three on the right are 7812 12v :
Here is a look at the back of the I/O board. This picture was taken before many of the solder joints failed. I had to rip off most of the heat glue over time to repair the bad joints.
Here is a look at the CPU board. The two 74154s are on the left. The Z-80 is on the right, and a 1 Mhz crystal oscillator is in the top right corner.:
Front panel lit up:
Another closeup of the lamps. Did I mention that I really like these 330 incandescent lamps?
The ritual of fixing cold solder joints:
This homebrew has been in five different houses, so the pictures vary a bit. It has take awhile to get this project wrapped up and documented.
|
|
